How to make a Perfect Cut

Compared to other saws, using a circular saw in making cuts can be quite tricky. Poorly operated saws can will fail to achieve clean cuts but can also result into injury. Today, we’ll guide you with some professional woodworkers do in order for them to make a perfect cut.

1.       Inspection

Before you go into cutting process, have a quick check on your circular saw. Check the blade for cracks and chips, if damage is present, change the saw immediately. If you are working with a cordless saw, check the batteries for any defects.

2.        Blade Check

After inspecting the saw, check the blade thoroughly. The performance and the cut quality depends on the blade. Cutting with a rusty or damaged blade isn’t recommended. There are designated blade for every material being cut. For example, using thin kerf carbide tipped combination can be used in cross cuts and rip cuts on solid wood and plywood.

3.       Positioning

Having the right position during the cutting process is important and there are rules in which direction you should cut in. The best possible position is that the saw with its motor facing towards the larger section of the board that isn’t falling away. The saw’s base plate will be fully supported during the cutting process.

4.       Wood Splintering

Place the board or a panel with the best surface facing down to avoid wood splintering. This way, the splinters will happen on the backside. When trimming doors down to the right size, place the best side down. Score along the edge with a knife and begin with the cut.

5.       Binding Prevention

Ensure proper support to eliminate kickbacks from the blade when cutting sheets of plywood or during paneling. Place a 2x4 underneath the sheet you are cutting, spacing one 2x4 close to the cut line. When you make the cut, the both halves will be supported by the 2x4.